| HAYLINER 268 BALER | SPECIFICATIONS | |
|---|---|---|
| Over-all width | 8' 3 ½” | |
| Over-all height | 4' 1 ½” | |
| Over-all length | bale chute up | 15’ |
| bale chute down | 17’ 9” | |
| Wheel tread | 7' 7 ½” | |
| Weight | Approximately 2474 lbs. | |
| Wheel bearing | Tapered roller | |
| Tongue offset | 19” | |
| Tire Sizes | Right | 5.00 x 15, 4 ply - 28# pressure |
| Left | 6.40 x 15, 6 ply - 44# pressure | |
| Pick-up (optional) | 3.00 x 12 - semi-pneumatic | |
| Left hand dual (optional) | Recommended 5.00 x 15 | |
| Right hand dual (optional) | Recommended 5.00 x 15 | |
| Bale Chamber | Size | 14" x 18" |
| Bale length | Adjustable 12" to 52" | |
| Feeding System | Drive | Telescoping linkage to plunger |
| Protection | Spring loaded | |
| Tines | 6 spring loaded aluminum fingers | |
| Feed opening | 266 square inches | |
| Drive bearings | Sealed ball and tapered roller | |
| Knotter | Protection | Shear bolt |
| Tying | Twine | |
| Plunger | Speed | 65 to 75 strokes per minute |
| Stroke | 30” | |
| Rollers | 7 sealed ball bearings (5 vertical, 2 horizontal | |
| Safety latch | Contacts crank arm | |
| Crank pin | Sealed ball bearing | |
| Plunger pin | Sleeve bearing with seals | |
| Main Drive | Flywheel diameter | 22” |
| Power | 2 - 3 plow tractor | |
| P.T.O. | 2 joint A.S.A.E. standard | |
| Protection | Shear bolt, overrunning and slip clutch | |
| Gearbox | Alloy steel gears running in oil | |
| Pick-up | Width (including 5 ½”flare) | 61 ½” |
| Pick-up drive | V-belt | |
| Protection | Belt acts as clutch on driven sheave | |
| Reel diameter | 12" | |
| Drive and driven bearings | Sealed ball | |
| Standard | Supersweep | |
| Number of tooth bars | 4 | 6 |
| Number of teeth | 48 | 120 |
| Tooth spacing | 4 ⅜” | 2 ⅝” |
| Tooth bar bearings | Self-lubricating | Sealed ball |
New Holland Hayliner 268 Baler Specifications
Below are the general dimensions for the New Holland Hayliner 268 Baler. You can find the manual here.